|
|
|
 OZONATED
WATER
Convert Normal Tap Water into a Super Cleaner!
|
 |
Ozonated Water Research and Approvals
Lab Testing of Ozonated Water
Sponsored lab test results from BoiE Always Ready devices confirm ozone's ability
to destroy bacteria and viruses in as little as 30 seconds. Ozonated water has been scientifically proven to disinfect
even at relatively low concentrations with appropriate contact time.
| Microbes Tested¹ |
Reduction
|
Contact
|
Sponsor
|
| MS2 phage ATCC 15597-B1 (Virus) |
99.9999%
|
30 sec
|
BoiE
|
| ¹Claim: Antiviral effectiveness against a non-enveloped virus that is harder-to-kill
than the SARS-CoV-2 enveloped virus that causes COVID-19. Double replicate testing performed at Microchem Laboratory,
Round Rock, TX on 6/30/2021. Standard: ASTM E2315 Liquid Suspension Time Kill Test. |
| Microbes Tested² |
Reduction
|
Contact
|
Sponsor
|
| Escherichia coli (E.coli) |
99.9999%
|
30 sec
|
BoiE
|
| Staphylococcus aureus (Staph) |
99.9999%
|
30 sec
|
BoiE
|
| ²Claim: For use as a food-contact sanitizer on hard, non-porous surfaces. Double
replicate testing performed at Microchem Laboratory, Round Rock, TX on 4/29/2021. Standard: AOAC 960.09 Germicidal
and Detergent Sanitizing Action of Disinfectants. |
| Microbes Tested³ |
Reduction
|
Contact
|
Sponsor
|
| Staphylococcus aureus |
>99.99%
|
30 sec
|
BoiE
|
| Klebsiella pneumoniae |
>99.99%
|
30 sec
|
BoiE
|
| Listeria monocytogenes |
>99.99%
|
30 sec
|
BoiE
|
| Salmonella typhii |
>99.99%
|
30 sec
|
BoiE
|
| ³Claim: For use as a non-food-contact sanitizer on hard, non-porous surfaces.
Testing performed at Microchem Laboratory, Round Rock, TX on 2/11/2021. Standard: ASTM E1153 Test Method for Efficacy
of Sanitizers Recommended for Inanimate Non-Food Contact Surfaces. |
Aqueous Ozone Approvals
Aqueous Ozone is approved by the EPA, FDA, USDA, is considered GRAS, and is
compliant with the EPA Organic Program as a natural and effective cleaner and sanitizer.
- The FDA approved Aqueous Ozone as an antimicrobial agent in 2001
- USDA/National Organic Program (NOP) Ozone Approved
- Nonfood Compounds Program listed on White List as a no-rinse sanitizer and cleaner
- GRAS and compliant with the EPA Organic Program
Identifying Aqueous Ozone Concentration
Ozone concentration in water from 0.0 to 1.5 ppm can be confirmed using commercially
available ozone test strips. Using an ozone test strip is simple: Gently dip the test strip into the ozonated water
for 5 seconds with constant, gentle back and forth motion (10 half strokes). Remove the strip and shake once briskly
to remove excess water. Wait 30 seconds then match the strip to the color chart. A minimum concentration of 0.25
ppm is all that is required for disinfection with sufficient contact time. These ozone test strips are availble
for purchase when ordering.
Office Hours 8am - 8pm CST Mon.-Fri. CST, 9am - 1pm Sat. Call 800-432-4418
  
©
BOI Environmental (BoiE). All rights reserved.
|
